How Freezing Temperatures Affect Commercial Refrigeration in Bellingham and Ferndale

Oct 12, 2026

Every winter, the first real cold snap brings the same phone call. A restaurant owner in Bellingham or a store manager in Ferndale says, "It's 20 degrees outside. Why is my walk-in cooler struggling?"

It makes sense to think freezing weather would make a refrigeration system's job easier. The cold air is right there, after all. But commercial refrigeration equipment is built to run within a certain temperature range, and when it gets too cold outside, things can go wrong in ways most business owners don't expect.

Our office is in Ferndale, and we've been servicing refrigeration across Whatcom County since 1990. We know what a Fraser River outflow does to rooftop equipment, because we're the ones up on those roofs the morning after. Here's what we see every winter and what you can do about it.

Cold Weather Still Puts Stress on Your Equipment

A refrigeration system needs a certain amount of pressure on the high side to work properly. When outdoor temperatures drop well below freezing, the condenser can reject heat too well. Head pressure falls, and the system can't feed enough refrigerant to the evaporator.

That leads to a chain of problems. Cooling capacity drops, the compressor may not get proper oil return, and refrigerant can migrate to places it shouldn't be during off cycles. Over a winter, that adds up to extra wear and a shorter compressor life.

Systems set up for low-ambient operation handle this fine. They use head pressure controls, fan cycling, and crankcase heaters. But a lot of equipment out there was never set up for it, or the controls have drifted out of adjustment over time.

North Winds, Ice, and Your Condenser

Anyone who has lived in Bellingham or Ferndale through a few winters knows the north wind. When arctic air pushes down the Fraser Valley, we get hard, dry, bitter wind, and sometimes freezing rain right behind it.

Air-cooled condensers take the brunt of it. Ice and blowing snow can coat the coil and block airflow. Freezing rain can lock up fan blades. Wind blowing straight across a condenser can also confuse the fan cycling controls, which makes the unit short-cycle: it turns on and off over and over. That's hard on compressors, contactors, and motors.

If your condensers sit on a rooftop or along an exposed wall, it's worth knowing which way they face and whether they have any wind protection.

Frozen Drain Lines and Iced-Up Evaporators

Walk-in freezers depend on defrost cycles to clear the evaporator coil, and that melt water has to drain somewhere. If a drain line runs through a cold space without working heat tape, it can freeze solid. Then the water backs up into the drain pan, overflows, and turns into ice on the floor or inside the unit.

That's a slip hazard for your staff. Over time it also leads to corrosion and electrical problems. And once ice builds up on the evaporator coil, airflow drops, the box warms up, and your energy bill climbs.

A mistimed defrost cycle or a failed defrost heater usually shows up in winter first, so that's a big part of what we check on our commercial refrigeration maintenance visits.

Door Gaskets and Heat Loss

Door gaskets stiffen up in the cold. A gasket that was a little worn in September can be cracked and leaking by January. Every gap lets warm, moist air into the box, so the system runs longer and the evaporator frosts up faster.

Run your hand along the door seals on your walk-ins and reach-ins once a month through the winter. If you feel a draft or see torn rubber, get it replaced. It's one of the cheapest fixes in refrigeration and one of the easiest to overlook.

Power Outages and Winter Storms

Whatcom County gets its share of winter outages, especially when wind and ice bring trees down onto lines out toward Ferndale, Lynden, and the county roads. Even a short outage or a flicker can damage the electronic controls in newer systems. Sometimes it also leaves equipment in a state where it doesn't restart properly on its own.

A few things that help:

  • Surge protection on refrigeration controls and compressors
  • Temperature alarms that notify you by phone, not just a light on the panel
  • A plan for who checks the equipment after power comes back, especially on a weekend
  • Knowing who to call. Our 24/7 emergency service is there for exactly these nights.

Farms and Cold Storage Through the Off Season

Winter looks different for our agricultural customers. Many berry farm refrigeration systems in the Nooksack Valley sit idle or run lightly after harvest. Some storage rooms keep running all winter in buildings that get a lot colder than a grocery store.

Idle equipment has its own risks. Refrigerant migrates, controls get bumped, and small leaks go unnoticed until startup in the spring. Winter is the best time to inspect, repair, and upgrade before the season starts. That goes for berry growers, bulb growers, and breweries that need steady temperatures year round.

What We Check Before and During Winter

When we do a winter service call, here's what's on our list:

  • Low-ambient controls and head pressure settings
  • Condenser coils, fan blades, and motors, cleared and working
  • Crankcase heaters
  • Drain lines and heat tape
  • Defrost timers, heaters, and termination settings
  • Door gaskets, door heaters, and closers
  • Electrical connections, contactors, and early signs of wear on compressors and motors

None of this is complicated, but it does need to be done before the first hard freeze, not after.

The Bottom Line

Freezing temperatures don't give your refrigeration a break. For many systems in Bellingham and Ferndale, winter is when hidden problems finally show up. A little seasonal attention keeps your product safe, keeps your energy costs down, and keeps you from making a 2 a.m. phone call in the middle of an ice storm.

If you run a restaurant, a grocery store, a farm, or any business that depends on cold storage, we'd be glad to help. Learn more about our commercial refrigeration services, ask about commercial refrigeration installation if your equipment is near the end of its life, or call us at 360-384-3203. We're right here in Ferndale, and we've been taking care of our neighbors' equipment for more than 35 years.

i 3 Table Of Content

girl with bag next to palm tree pointing out to the beach.

Get your FREE Estimate

“Free Estimates” refers to an estimator coming to give you an estimate for replacements or installations. In a service call, our service technician comes to diagnose and repair the problem, where we have to charge our service rate and travel time.

Step 1 of 2